1.Clean shaft,bore,and outside of bushing,and bore of hub(taking bushing from hub if already assembled).Remove any oil.lacquer,or dirt.Placing bushing in hub and match half holes to make complete holes(each complete hole will be threaded on one side only).
2.Oil thread and point of set screws or thread and under head of cap screws.Place screws loosely in holes thatare threaded in hub one side see install bore.
3.Make sure bushing is free in hub.Slip assembly onto shaft and locatd in position desired.
4.Tighten screws alternately and evenly until all are pulled up very tightly.Use a piece of pipe on wrench to increase leverage,please refer to taper bushing screw torque which need to be asked.
Taper lock bushing features:
1.Surface treatment: Black-phosphated or original color without finishing
2.Easy on-easy off
3.Machined to high precise tolerance
We are continually exploring opportunities to engage with like-minded companies seeking to establish mutually beneficial and strategic long-term working relationships. We sincerely look forward to hearing from you in the near future.
we are provide taper bushing installation,we can guarantee quality.