Customer Question & Answer
1.Material:Cast iron or steel
2.Process: sand mold casting,machining
3.Bore: pilot bore, finished bore, taper bore
4.Surface finish: black oxide,paint, phosphating
Taper Bushings From Factory
Taper lock bushing to install
1.Clean shaft,bore,and outside of bushing,and bore of hub(taking bushing from hub if already assembled).Remove any oil.lacquer,or dirt.Placing bushing in hub and match half holes to make complete holes(each complete hole will be threaded on one side only).
2.Oil thread and point of set screws or thread and under head of cap screws.Place screws loosely in holes thatare threaded in hub one side see install bore.
3.Make sure bushing is free in hub.Slip assembly onto shaft and locatd in position desired.
we are taper bushings from factory,we can guarantee quality.